OCT10/GB Issue 4d 1 Installation & Operating Instructions Covering Models: Monterrey 5 SE, Monterrey 7 SE, Monroe
OCT10/GB Issue 4d 10 Combustion Air Requirements In order for the stove to perform efficiently and safely there should be an adequate air sup
OCT10/GB Issue 4d 11 Assembly The diagram below shows the stove with all internals taken out. To take internals out of the stove follow the n
OCT10/GB Issue 4d 12 Assembly It is possible to remove the stove from the store (Monterrey log store versions) this may be necessary for tran
OCT10/GB Issue 4d 13 Assembly Smoke exempt modification Your stove will come pre-set for use in a smoke control zone. The threaded bar indic
OCT10/GB Issue 4d 14 Controls Layout The stove is fitted with two air controls which need to be correctly operated in order to light and main
OCT10/GB Issue 4d 15 Controls Explained Primary Air Intake The primary air intake is the bottom slider situated below the ash lip at the fro
OCT10/GB Issue 4d 16 Recommended Fuels This appliance has obtained approval from HETAS Ltd., for burning – * HETAS approved coal suitable
OCT10/GB Issue 4d 17 Lighting the Stove Curing On initial firing you will notice a very pungent odour, this is caused through the curing of
OCT10/GB Issue 4d 18 Burning Wood Once you have kindled your stove (see previous page) and your chimney (flue) is sufficiently heated, you ar
OCT10/GB Issue 4d 19 Smoke Exempt Requirements The Clean Air Act 1993 and Smoke Control Areas Under the Clean Air Act local authorities may d
OCT10/GB Issue 4d 2 Contents Introduction 3 Packing List 3 Health & Safety 4 Specifications
OCT10/GB Issue 4d 20 Lighting Sequence (in smoke controlled areas) Using the approved appliance in a smoke controlled area Ignition sequence
OCT10/GB Issue 4d 21 Maintenance Ash Removal The ash pans can be removed by using the ash tool to hook it forward so that you can grasp the
OCT10/GB Issue 4d 22 Trouble-shooting Smoke comes out of the stove when the loading door is opened. • The chimney cavity into which the 125
OCT10/GB Issue 4d 23 Commissioning Form Commissioning Statement and Check-list Stove Purchased From:________________________________________
OCT10/GB Issue 4d 24 Spare Parts (1) Side (2) Front (3) Glass Clip (4) Left Firebrick (5) Lid (6) Spigot (7) Baffle (8) Grate (9) Ash Pa
OCT10/GB Issue 4d 25 EC Declaration DECLARATION OF CONFORMITY ACCORDING TO DIRECTIVES 89/106/EEC (CONSTRUCTION PRODUCTS) ISSUED
OCT10/GB Issue 4d 26 EC Declaration DECLARATION OF CONFORMITY ACCORDING TO DIRECTIVES 89/106/EEC (CONSTRUCTION PRODUCTS) ISSUED
OCT10/GB Issue 4d 27 Annual Service Record 1ST YEAR SERVICE completion date: SERVICE ENGINEER: REG. No. COMPANY NAME: .
OCT10/GB Issue 4d 28 Warranty This appliance must be installed and commissioned by a fully qualified, registered engineer. A “Declaration of
OCT10/GB Issue 4d 3 Introduction May we take this opportunity to thank you for choosing one of our cast iron, multifuel stoves. The term m
OCT10/GB Issue 4d 4 Health & Safety Special care must be taken when installing the stove such that the requirements of the Health and Sa
OCT10/GB Issue 4d 5 Specifications In the UK these stoves have been approved by HETAS Ltd as intermittent heating appliances for burning coa
OCT10/GB Issue 4d 6 Dimensions Monroe 5 SE Monroe 7 SE Monterrey 5 SE Monterrey 7 SE
OCT10/GB Issue 4d 7 Dimensions Monterrey 5 SE Logstore Monterrey 7 Logstore
OCT10/GB Issue 4d 8 Hearth Requirements & Clearances These appliances are ALL suitable for the minimal 12mm hearth's and do not requ
OCT10/GB Issue 4d 9 Chimney Requirements This appliance must not be fitted into a chimney serving another heating appliance. It is most impor
Comments to this Manuals