Broseley Canterbury Instruction Manual

© 2007-2008 Broseley Fires Ltd Installation, Servicing and Operation Manual CCaanntteerrbbuurryy SSlliimm LLiinnee GGaass SSttoovvee

© 2007-2008 Broseley Fires Ltd 2. Position a coal on each of the platforms on the centre coal. 3. Place a coal on either side, restin

© 2007-2008 Broseley Fires Ltd Arranging the Layout of the Coals - Propane 1) Position the first large coal matrix on the burner as shown. This co

© 2007-2008 Broseley Fires Ltd 4) Place the final layers of coals bridging the gap between the first and second large coal matrixes. These should

© 2007-2008 Broseley Fires Ltd THE FOLLOWING ARE IMPORTANANT WARNINGS RELATIVE TO THE SPILLAGE MONITORING SYSTEM 1. The installer must not attempt

© 2007-2008 Broseley Fires Ltd EXTINGUISHING THE STOVE FULLY 1. From any heat setting or the permanent pilot, depress control knob and turn clockwi

© 2007-2008 Broseley Fires Ltd Servicing Instructions Servicing should be carried out annually by a qualified installation engineer when the stove

© 2007-2008 Broseley Fires Ltd AND FINALLY…….. We would remind you that it is a legal requirement that the stove is installed by a qualified and acc

© 2007-2008 Broseley Fires Ltd The Commissioning Sheet THIS SECTION MUST BE COMPLETED AND SIGNED BY THE INSTALLATION ENGINEER PLEASE LEAVE WITH TH

© 2007-2008 Broseley Fires Ltd Guarantee Dear Customer, Your decorative gas fire, when installed in accordance with the installation instructions

© 2007-2008 Broseley Fires Ltd Introduction THANK YOU FOR PURCHASING A GAS FIRED STOVE Broseley Fires Ltd, a family run company, was founded as an

© 2007-2008 Broseley Fires Ltd Technical Information Natural Gas Propane G20/I2H G31/I3P Heat Input (Gross) 5.5Kw 4.3Kw Supply Pres

© 2007-2008 Broseley Fires Ltd Sitting the Appliance The gas supply connection to the appliance is in the centre underneath the stove. The connec

© 2007-2008 Broseley Fires Ltd Stove Assembly To flue the stove into an existing fireplace Figure 1 shows the critical dimensions required. Please c

© 2007-2008 Broseley Fires Ltd Fitting the Burner 1) Insert the burner into the stove locating the burner bracket on to the fixing lugs provided.

© 2007-2008 Broseley Fires Ltd Fitting the Stainless Reflector Plate After fixing the burner in position fit the stainless reflector plate to the re

© 2007-2008 Broseley Fires Ltd Flue Connection Firstly you will need to attach the flue spigot to the rear of the stove using the 4 screws supplied.

© 2007-2008 Broseley Fires Ltd Pressure Testing Always make sure that there is adequate gas pressure and volume to the stove. The relevant pressures